| Step | | Procedure & Parts & Tools |
| 1 |
|
LAY THE MACHINE DOWN AND REMOVE THE 7 SCREWS FROM THE BASE BOTTOM.
| Screwdriver-phillips |
|
|
| 2 |
|
STAND THE MACHINE UP AND PULL UP ON BASE COVER TO REMOVE IT.
|
| 3 |
|
LOCATE THE CIRCUIT BOARD IN THE BASE. PULL UP ON THE CIRCUIT BOARD TO REMOVE IT.
|
| 4 |
|
LOCATE THE 2 RED WIRES ON THE CIRCUIT BOARD. PUT ONE LEAD ON EACH WIRE CONNECTOR. MAKE SURE THE MACHINE IS PLUGGED IN AND TURN POWER ON. ACTIVATE THE BRUSH MOTOR. SET THE VOLT METER TO VOLTAGE. VOLT METER SHOULD READ APPROX. 120 VOLTS.
| Volt meter (True RMS capable) |
&Width=100)
|
|